Handling and operation
NOTE
►
All functions can be used with the buttons on the device as well as with the
remote control
This section provides you with important information on handling and using the
appliance.
Switching the appliance on and off
The main switch
♦
Insert the power plug into a mains wall socket.
♦
Switch on the appliance using the main switch
switch last if you are no longer using the appliance.
♦
When switched on, the integrated control lamp in the main switch
There will be a beep and the display
♦
Now press the on/off button
Selecting the temperature
NOTE
►
The display
temperature
►
The temperature measurement is made by the temperature sensor
take some time until the whole room has reached this temperature.
♦
Press the button (°F / °C)
ther the temperature display uses °C or °F.
The selected unit of measurement
♦
Press the „Increase temperature" button,
temperature
The selected target temperature
♦
Press the „Decrease temperature" button,
temperature
The selected target temperature
Select heat setting
The heat setting determines how quickly the appliance warms up.
The appliance has three heat settings:
■
Level 1: 1000 watts
■
Level 2: 1300 watts
■
Level 3: 2300 watts
♦
Press the button to select the heat setting
red heat setting has been set.
The selected heat setting
SKD 2300 D4
25
.
8
disconnects the appliance fully from the mains power supply.
21
or
2
shows the set target temperature
20
.
28
23
or
13
19
up to a maximum of 37°C (99°F).
19
19
down to a minimum of 5°C (41°F).
19
10
is shown on the display
8
first; or switch off at the main
2
lights up.
33
. The appliance is now ready for use.
19
and measured actual
to select the unit of measure, to select whe-
is shown on the display
15
32
or
, to increase the target
is shown on the display
29
16
or
, to decrease the target
is shown on the display
24
26
or
repeatedly until the desi-
2
.
8
lights up.
7
. It may
2
.
2
.
2
.
GB │ IE
│
31
■