Before Initial Use; Electrical Connection; Inserting/Changing The Remote Control Battery; Fitting The Feet - Silvercrest SKD 2300 D4 Instrucciones De Uso

Before initial use

■ Remove all packaging materials and all transport locks from the appliance.
NOTE
► You may notice a slight smell when using the appliance for the first time. This is
normal and is completely harmless.

Electrical connection

To ensure safe and trouble-free operation of the appliance after making the electrical
connection, please observe the following advice:
CAUTION
► Before connecting the appliance, compare the connection data (voltage and
frequency) on the rating plate with that of your mains power supply. These data
must agree so that no damage is sustained by the appliance.
► Ensure that the mains power cable is not damaged and is not running over hot
surfaces and/or sharp edges.
► Ensure that the mains power cable is not taut or knotted.

Inserting/changing the remote control battery

If the battery in the remote control
inserted.
♦ Open the battery compartment
(see description on the rear of the remote control
♦ Remove the old battery from the remote control
NOTE
► Please follow the disposal instructions (see section Disposing of the batteries).
♦ Insert a new CR2032 battery into the battery compartment
Ensure the +/- terminals are correctly aligned.
♦ Slide the battery compartment

Fitting the feet

♦ Place the appliance upside down on a soft surface, e.g. a carpet.
♦ Fit the feet
SKD 2300 D4
25
30
30
6
to the bottom of the appliance using 2 screws
is dead, a new CR2032 battery needs to be
on the underside of the remote control
25
).
25
.
back into the remote control
25
30
.
25
.
34
on each foot.
GB │ IE │
29 ■