Publicidad
Idiomas disponibles
Idiomas disponibles
9
EN
STORAGE
When storing or transporting the chain saw, always place
the protective cover over the chain saw blade. When the
tool will not be used for several months, ideally leave the
battery connected to the charger. Otherwise proceed as
follows:
■ Fully charge the battery.
■ Remove the battery from the tool.
■ Store the tool and battery in a secure and dry location.
The storage temperature must always remain in the
range of +10°C to +40°C. Place the battery on a level
surface.
■ Before using the tool after prolonged storage, fully
charge the battery again.
ENVIROMENT PROTECTION
1) Environmental protection should be a priority of
considerable importance when using the machine, for the
benefit of both social coexistence and the environment in
which
we live. Try not to cause any disturbance to the
surrounding area.
2) Scrupulously comply with local regulations and
provi¬sions for the disposal of packaging, oils, petrol,
filters, damaged parts or any elements which have a
strong impact on the environment; this waste must not
be disposed of as normal waste, it must be separated
and taken to specified waste disposal centres where the
material will be recycled.
3) Scrupulously comply with local regulations for the
disposal of waste materials after mowing.
4)
When
decommissioning,
environment with the machine, but hand it over to a
disposal centre, in accordance with the local laws in
force.
DISPOSAL
Do not dispose of electrical equipment with household
waste material. In observance of European Directive
2012/19/EC on waste electrical and electronic equipment
and its implementation in accordance with national
regulations, electric equipment that has reached the end
of its life must be collected separately and recycled in
an ecologically compatible way. If electrical equipment
is disposed of in dumps or in landfills, hazardous
substances can leak into the groundwater and get into
the food chain, damaging your health and well-being.
For further information on the disposal of this product,
contact a domestic waste collection authority or your
dealer.
do
not
pollute
the
MAINTENANCE/TROUBLESHOOTING
8. TROUBLESHOOTING
POLE HEDGE TRIMMER
Fault
Possible
Tool will
Battery not
not start
installed properly
Battery discharged
Lock-off button
not actuated
Pole connections
not properly
tightened
Battery
Battery not
will not
installed properly
charge
POLE SAW
Fault
Possible
Bar and
Check chain
chain
tension
running hot
for overtightened
and
condition.
smoking.
Bar lube
reservoir
empty.
Motor runs,
Chain tension
but
too tight.
chain is not
Check guide bar
rotating.
and
chain assembly.
Check guide bar
and
chain for
damage.
Action
Check the battery
installation
Fit a (fully) charged
battery
Observe the starting
procedure
Check the
connections
Check the battery
installation
Action
Tension chain.
Refer to Chain
Tension earlier in
this manual.
Check bar lube
reservoir.
Retention chain.
Refer
to Chain Tension
earlier
in this manual.
Refer to Replacing
the
Bar and Chain
earlier in
this manual.
Inspect guide
bar and chain for
damage.
Publicidad
