Cognex VisionView 700 Manual Del Usuario página 6

1
Mount VisionView
1. Cut a mounting hole in the panel. (Refer to the VisionView 700
Dimensional Drawings on page 10.)
Note: It is strongly recommended that a professional machine shop cut
the mounting hole in the panel.
2. Place VisionView face-down on a clean, fl at surface.
3. Slide the rubber gasket around the back of VisionView, until it rests
directly against the back of the VisionView faceplate.
4. Slide the panel cutout around the back of VisionView, until the panel
rests directly on the rubber gasket.
4