Cognex VisionView 700 Manual Del Usuario página 7

5. Insert an M4 set screw into a mounting clip and fi nger-tighten the screw
until it is partially threaded in the mounting clip.
6. Insert the mounting clip into one of the 8 insertion points located on the
perimeter of the display.
7. Holding the mounting clip fi rmly in place, fi nger-tighten the set screw.
Finish tightening the set screw; maximum torque 0.2259 Nm (2 in-lb) if
using a 3mm hex wrench (1 to 1 ½ turns past fi nger-tight).
8. Repeat for the 7 remaining set screws and mounting clips until
VisionView is securely attached to the panel, ensuring the rubber gasket
remains in place. If properly mounted, less than 1.5mm of the rubber
gasket should be visible around the front perimeter of the VisionView
display.
5