Technical Data; Noise And Vibration Information; Troubleshooting Guide - MIRKA CEROS150NV Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 35

Technical data

Compact Electrical Random Orbital Sander
Power
Mains Voltage
DC voltage to sander
Speed
Orbit
Size of backing pad
Weight
Degree of power supply protection
Degree of protection of the sander

Noise and vibration information

Measured values are determined according to EN 60745.
Compact Electrical Random Orbital Sander
Sound pressure level (L
)
pA
Sound power level (L
)
WA
Sound measurement uncertainty K
Vibration emission value a
h
Vibration emission uncertainty K

Troubleshooting guide

Symptom
No light from power supply LED when
switched on.
The sander LED is red and the sander
slows down to 4000 RPM when sanding.
The sander LED is red and RPM is
slightly reduced.
The sander LED is red and RPM is
slightly reduced.
CEROS150NV
50 W
90–240 VAC
22 VDC
4,000–10,000 rpm
5.0 mm
Ø 32 mm
587 g
I
CEROS150NV
47.4 dB(A)
58 dB(A)
2 dB
1.8 m/s
2
1.5 m/s
2
Possible cause
Power cord not properly attached to power
supply unit or to the mains socket.
Faulty fuse.
Too heavy long term load.
Temperature too high in the sander. Too
heavy long term load.
Too heavy short term load.
Solution
Connect it properly.
Replace the fuse.
Use lighter load. Switch off the power.
Wait 5 seconds. Switch on again.
Reduce load on the sander for some time
and the sander will speed up again.
Use lighter load and the LED will
automatically change to green.
Mirka® CEROS150NV • 32 mm (1 in.) 
en
33

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido