Publicidad
Idiomas disponibles
Idiomas disponibles
A) Charging the Battery
NOTE:
Prior to initial use, the battery must
be charged 5 hours to fully utilize the
battery capacity.
B) Charging
Connect the USB-C cable to the
charger, and plug the charger into the
matching socket. During the charging
process, the green light will flash; after
the charging is completed, three cells
of the green light will always be on.
Unplug the charger and disconnect the
charging cable from the machine. The
machine is ready to be used.
Important notice:
During the charging process, the
charger and the body surface will feel
12
hot, which is a normal phenomenon.
Note :the USB-C cable is suitable for
the charger ,of which the output is 5V
1000mA
ASSEMBLY AND ADJUSTMENT
Inserting and Removing Bits
Forward / reverse operation
Torsion adjustment
The torque of three gears can be
adjusted according to the demand by
using the torque adjustment button
3. The machine has its own torque
protection function,
1st gear:
Suitable for screwing in or out small
diameter screws
3rd gear:
Suitable for screwing in or out large
See Fig A
diameter screws
OPERATION
Torsion adjusting
Before each use, please
adjust to the appropriate
torque gear, otherwise it's easy to
slip
Power display operation
Press and hold the power display
button 3 for more than 3 seconds
MAINTENANCE
See Fig B
Your power tool requires no additional lubrication or
See Fig C,D
maintenance. There is no user serviceable parts in your
power tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place.
See Fig E
See Fig E
See Fig F
Publicidad
