Care And Maintenance; Maintenance Table - Hilti DSH 600-X Manual De Instrucciones

7

Care and maintenance

WARNING
Risk of injury. Touching the rotating cut-off wheel or hot parts of the machine may lead to injury or burns.
▶ Switch the engine off and allow the product to cool down before all maintenance, repairs, cleaning or
servicing.
7.1

Maintenance table

1 - Before starting work | 2- Every six months | 3 - As necessary
Check that all externally accessible nuts and screws are securely tightened.
Check that the tool is complete, in perfect condition and free of leaks.
→ repair as necessary
Check for foreign matter.
→ repair as necessary
Check that the controls are in full working order.
→ repair as necessary
Check that the cut-off wheel is in perfect condition.
→ replace as necessary
Check the fuel filter for clogging.
→ replace as necessary
Replace the air filter if the product does not start or engine performance fades
noticeably.
Clean or replace the spark plug if the product does not start or is difficult to start.
Adjust the idling speed if the cut-off wheel does not slow to a standstill when the
engine is idling.
Have the product repaired by Hilti Service if the drive belt slips when a load is
applied to the cut-off wheel.
7.2 Cleaning or replacing the air filter
ATTENTION
Risk of damage. Entry of dust causes irreparable damage to the product.
▶ Never operate the machine if the air filter is damaged or missing.
▶ When changing the air filter, the product should stand upright and should not be laid on its side. Take
care to ensure that no dust finds its way onto the underlying filter screen.
Change the air filter if engine performance drops noticeably or if the engine becomes difficult to start.
1. Release the securing screw on the air filter cover and remove the cover.
2. Carefully remove the dust adhering to the air filter and the filter chamber (use a vacuum cleaner).
3. Remove the air filter.
4. Insert the new air filter.
5. Fit the air filter cover and tighten the retaining screws.
7.3 Replacing a broken starter cord
ATTENTION
Risk of damage. The housing may suffer damage if the starter cord is too short.
▶ Never continue to use a broken starter cord. Replace it immediately.
1. Release the four securing screws and remove the starter assembly.
2. Release the two screws securing the cover and remove the cover.
3. Remove the remains of the broken starter cord from the spool and the pull handle.
34 English
10
11
2136486
1 2
× ×
×
×
×
×
×
*2136486*
3
×
×
×
×
×
×