Safety Information - Peak 3D MULTIHORSE 5201 Manual Del Usuario

Table Assembly Instructions

Safety Information

• IMPORTANT: READ THE ENTIRE SAFETY INFORMATION SECTION AT THE BEGINNING OF
THIS MANUAL BEFORE SET UP OR USE. READ ALL INSTRUCTIONS CAREFULLY. FAILURE
TO FOLLOW ALL INSTRUCTIONS CAN RESULT IN DEATH OR SERIOUS INJURY.
• Do not build a Table higher than 3' (0.91 m) and larger than 8' (2.43 m) long by 4' (1.21 m) wide.
Required materials
- Two 2x4 Long Stringers - max. length 8' (2.43 m)
- Two 2x4 Short Stringers - max. length 41" (1.04 m)
- Two 2x4 Spacers - max. length 4' (1.21 m)
- One 4' x 8' x ¾" (1.21 m x 2.43 m x 19 mm) sheet of plywood
- Four 2x4 Legs - max. length 3' (0.91 m)
- Sixteen #10x1¼" (32 mm) wood screws (provided)
- Twenty-two #10x2" (51 mm) wood screws (not provided)
Note: All lumber must be No. 1 structural grade that is free of cracks, splitting, loose or
large knots, decay, twist, and/or any other defect.
Installation
1. Begin by placing the Long and Short
Stringers on a flat level surface.
2. Attach the plywood sheet to the Stringers
using twenty-two #10x2" (51 mm) wood screws
spaced not more than 16" (406 mm) apart.
38.10 393.70
the Short Stringers should
be 10¼" (260 mm) from the
ends of the Long Stringers.