Suntec Wellness Heat Stream 2000 slim Manual De Instrucciones página 15

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 19
air outlet must be facing downwards.
Warning: In order to avoid overheating, do
not cover the heater!
Assembly
Please remove all packaging materials and check all components for visible damage. In the event of damage,
please do not proceed with the assembly and contact your point of sale. The following assembly steps refer to
the figures at the beginning of this manual.
1. Select a wall that is suitable for installing the appliance. The wall must be stable, straight and not be
made of highly flammable material, e.g. polystyrene or textiles. There must be no obstacles to
installation behind the wall, e.g. cables. The unit may only be installed in zone 3 or the "safe zone" (Fig.
1).
2. Drill three holes with a diameter of 8mm each into the wall. The positions and distances are shown in
fig.2. Insert pegs into the holes.
3. Fix two screws at the positions A and B. The screws must protrude 10mm to be able to hang the unit.
4. Fix a screw at position C. This screw needs to be fixed tightly.
Operation
Operating voltage: 220-240V~, 50Hz, 1800-2000W
Control panel:
LED display
Week timer/
Week
On/Off indicator
On/Off button
Mode button
Fan
1-24h timer
Timer button
Heating 1000W
Heating 2000W
Open window sensor/
Hour
On/Off timer/
Minute

Publicidad

Tabla de contenido
loading

Tabla de contenido