Software 1249B (R.I. 003 - Sw Rev. 2.3 Or Higher); Info; External Data Management; Installing The Usb Driver For Connecting Art. 3471 To A Pc - Comelit 3471 Manual Tecnico

3. Info

From this menu it is possible to view:
• the number of names listed in the directory
• the number of passwords entered
• the number of keys entered
• the RS485 address
• the software version.
1. Access programming mode, see page 17.
2. Select: INFO
3. Scroll using
.
4. Press
to exit.

4. External data management

Software 1249B
4.1 Installing the USB driver for connecting Art.
3471 to a PC
This software can only be used while access control is disabled
(see "2.6 access control").
Make sure that the option to install unsigned drivers (drivers that
have not passed Windows Logo testing) is enabled
1. Connect the cable attached to Art. 1249B to the USB connector on
the rear of the directory module.
2. Access programming mode, see page 17.
3. Select: Settings/Type of download/USB.
TYPE OF DOWNLOAD
OFF
*USB
RS485
OK
SCROLL
4. The messages "Found new hardware Art. 3471" and "New hardware
installation wizard" appear on the PC
instructions through to completion.
CAUTION: select the Drivers folder located in the Art. 1249B
installation folder

4.2 Using the directory via software Art. 1249B

CAUTION: connection to the PC takes place via USB; make sure
that the drivers have been installed, see section "Installing the
USB driver for connecting Art. 3471 to a PC"
1. Connect the cable attached to Art. 1249B to the USB connector on
the rear of the directory module.
2. Access programming mode, see page 17.
3. Select: Settings / Type of download / USB.
TYPE OF DOWNLOAD
OFF
*USB
RS485
OK
SCROLL
4. Run software Art. 1249B.
5. Run the download procedure and wait until it is complete.
The system type and call mode selected must correspond with
those set on module Art. 3471, see section "2.5 Call management".
Make sure in "Parameters configuration" on Art. 1249B that the
correct communication port is selected
If the power supply is cut off while the data downloaded via USB
is being saved, the option of resuming the save process will be
displayed on the LCD next time the unit is started up
28 28
(R.I. 003 - SW rev. 2.3 or higher)
OK
ESC
Follow the installation wizard
.
OK
ESC

4.3 Multidownload

It is possible to use an RS485 network to connect multiple Art. 3471
modules to the same PC with software Art. 1249B installed.
Each module must have a different ID CODE (RS485 address), see
section "2.2 RS485 address".
1. Connect the RS485 serial cables to terminals 485D+/485D- on Art.
3471 (see diagram on page 100).
2. Access programming mode, see page 17.
3. Select: Settings/Type of download/RS485.
TYPE OF DOWNLOAD
OFF
USB
*RS485
OK
SCROLL
4. Run software Art. 1249B.
5. Run the download procedure and wait until it is complete.
The system type and call mode selected must correspond with
those set on module Art. 3471 (see section "2.5 Call management").
Make sure in "Parameters configuration" on Art. 1249B that the
correct communication port is selected
OK
ESC