Maintenance And Care - Flex LP 1503 VR Instrucciones De Funcionamiento Originales

Operating instructions
`^rqflk>
tÜÉå=íÜÉ=ëíçåÉ=ÖêáåÇÉê=áë=ëïáíÅÜÉÇ=çÑÑI=
íÜÉ ÖêáåÇáåÖ=íççä=ÅçåíáåìÉë=êìååáåÖ=ÄêáÉÑäóK
Machining flat areas
 Hold electric power tool with both hands.
To give the surface a decorative finish:
 Carefully place the electric power tool on
the area to be machined and move the
power tool forwards and backwards in
a linear motion.
Working with the rubber air roller
The rubber air roller is particularly suitable for
sanding contours, as it can be adjusted to the
surface shape of the workpiece.
 Push sanding sleeves over the uninflated
rubber air roller.
 Remove valve cap. Inflate the rubber air
roller using the air pump.
 To release the air at the back of the valve
cap, open the valve.
20
Working with the sanding belt
 Mount drive roller on the tool holder.
 Place sanding belt (endless) around
the workpiece.
or
 Place Velcro sanding belt around the
workpiece and connect to Velcro drive belt.
 Place sanding belt over the drive roller.
 When sanding, do not overload the
sanding belt! Pull sensitively.

Maintenance and care

t^okfkd>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=ÉäÉÅíêáÅ=
éçïÉê=íççäI=éìää=çìí=íÜÉ=ã~áåë=éäìÖK
Cleaning
t^okfkd>
fÑ=ãÉí~äë=~êÉ=ïçêâ=çîÉê=~=éêçäçåÖÉÇ=éÉêáçÇI=
ÅçåÇìÅíáîÉ=Çìëí=ã~ó=ÄÉÅçãÉ=ÇÉéçëáíÉÇ=
áåëáÇÉ=íÜÉ=ÜçìëáåÖK
fãé~áêãÉåí=çÑ=íÜÉ=éêçíÉÅíáîÉ=áåëìä~íáçå>
léÉê~íÉ=íÜÉ=éçïÉê=íççä=îá~=~=êÉëáÇì~äJÅìêêÉåíJ
çéÉê~íÉÇ=ÅáêÅìáíJÄêÉ~âÉê=EíêáééáåÖ=ÅìêêÉåí=
PM ã^FK
Regularly clean the power tool and ventilation
slots. Frequency of cleaning is dependent on
the material and duration of use.
Regularly blow out the housing interior and
motor with dry compressed air.
LP 1503 VR