POLTI cimex ERADICATOR Manual De Instrucciones página 18

etc.), we recommend cleaning with a cloth
which has been steamed previously.
• Also on particularly delicate surfaces (e.g.
synthetic materials,
etc.) it is recommended to always cover
the brushes with a cloth and to use steam
to a minimum.
• If cleaning glass surfaces in particularly low
temperatures preheat the glass using the
hand gun from about 1.6 ft (50 cm) di-
stance from the surface to be cleaned.
• For care of your plants vaporise at a mini-
mum distance of 1.6 ft (50 cm).
TIPS
Here are some tips for using the steam con-
trol:
• Strong steam: to remove scale, stains,
grease and disinfect;
• Regular steam: to clean carpets, rugs, win-
dows, floors;
• Gentle steam: to steam plants, clean deli-
cate fabrics, wall coverings, sofas, etc.
USE OF THE ACCESSORIES
HOLDER
The accessories holder allows you to attach
the tube with the brush mounted on it to the
appliance body.
Repositioning the tube on the appliance
body: slide the groove on the back of the
brush into the guide of the accessories holder
on the appliance (Fig. 10).
CARE OF YOUR
CIMEX ERADICATOR
• Before carrying out any maintenance on
the device, always unplug it from the
power source making sure that the product
has cooled down before proceeding.
TIPS
• After using the brushes, we recommend
letting the bristles cool down in their natu-
ral position, in order to avoid any deforma-
tion.
• To clean the body of the appliance, simply
use a moist cloth.
• Regularly check the status of the coloured
washer located in the connector assembly
CIMEX ERADICATOR
lacquered surfaces
(R). If necessary, replace with the appro-
priate spare part (8), as described below.
- Remove the damaged washer.
- Insert the new washer, placing it on the
steam nozzle and pushing it until it is in its
place. See (Fig. B).
- Lubricate the gasket with silicone grease or
Vaseline® or alternatively with small quan-
tities of vegetable oils.
Fig. B
Make the same check also on the connec-
tion washers of the extension tubes (10)
and of the steam gun (9). If necessary, re-
place with the appropriate spare part (8),
as described below.
- Remove the damaged washer.
- Insert the new washer, placing it on the
steam nozzle and pushing it until it is in its
place. See (Fig. C).
- Lubricate the gasket with silicone grease or
Vaseline, or alternatively with small quanti-
ties of vegetable oils.
Fig. C
18