Technical Data - Hilti TE 60-AVR Manual Del Usuario

3.4 Possible misuse
• This product is not suitable for working on hazardous materials.
• This product is not suitable for working in a damp environment.
3.5 Undercut anchors
The product is suitable for setting undercut anchors. Use only suitable setting tools.
Detailed information on this topic can be obtained at your local Hilti Center.
3.6 ATC
The product is equipped with the ATC (Active Torque Control) quick-acting electronic cut-out.
If the accessory tool sticks or stalls, the product will suddenly pivot about its own axis in the opposite direction.
ATC detects this sudden pivoting movement of the product and switches the product off immediately.
For ATC to function correctly, the product must be free to pivot.
After an ATC cut-out, switch the product off and then on again.
3.7 Active Vibration Reduction
The tool is equipped with an Active Vibration Reduction (AVR) system which reduces vibration noticeably.
3.8 Quick-release chuck (accessory)
The quick-release chuck makes changing accessory tools a quick operation with no additional tools needed.
It is suitable for accessory tools with cylindrical or hexagonal shank used in the "Without hammering action
" mode.
3.9 Service indicator
The product is equipped with a service indicator LED.
3.9.1 Service indicator status
Status
The service indicator lights.
The service indicator blinks.
3.10 Items supplied
Combihammer, side handle, operating instructions.
3.11 Accessories and spare parts
Further information about other system products ap-
proved for use with your product can be found by scan-
ning this QR code or online at: www.hilti.group.
4

Technical data

4.1 Combihammer
When powered by a generator or transformer, the generator or transformer's power output must be at least
twice the rated input power shown on the rating plate of the power tool. The operating voltage of the
transformer or generator must always be within +5% and -15% of the rated voltage of the power tool.
The information given applies to a rated voltage of 230 V. The data may vary in the event of deviations from
the rated voltage and for country-specific versions. Please refer to the power tool's rating plate for details of
its voltage, frequency, current and input power ratings.
*2134963*
Meaning
End of service interval – servicing is due.
Have the combihammer repaired by Hilti Service.
2134963 English 17