Programming The Alarm System - Dometic MAGICSAFE MS 680 Instrucciones De Montaje Y De Uso

Programming the alarm system

9 Programming the alarm system
I
NOTE
The alarm system is pre-programmed for the Fiat Ducato x290.
9.1 Programming the vehicle code
The alarm system must be adjusted to the CAN bus of your vehicle type. The alarm
system is factory set to the vehicle code 131 for Fiat Ducato x250 and Fiat
Ducato x290.
If you need to reprogram the vehicle code, proceed as follows:
➤ Press the button (fig. 2 3) on the control unit and hold it down.
➤ When the LED on the control device (fig. 2 4) lights up, release the button.
✓ The LED goes out.
✓ After a pause of 4 seconds, the LED begins to flash.
➤ Count the number of flashes until the number agrees with the first number of your
vehicle code:
– One flash: Number 1
– Two flashes: Number 2, ...
– Nine flashes: Number 9
– Ten flashes: Number 0
➤ Press the button again.
✓ After a pause of 4 seconds, the LED begins to flash.
➤ Repeat the steps described above for all the digits of the vehicle code.
✓ After programming, the LED flashes the vehicle code.
➤ Test the alarm system by activating it with your remote control.
✓ When you correctly enter the vehicle code, the alarm system will be activated.
If the alarm system is not activated, you have not entered the vehicle code correctly.
Repeat the programming.
16
MS680
EN