Dometic MAGICSAFE MS 680 Instrucciones De Montaje Y De Uso página 24

Using the alarm system
➤ Switch off the ignition when you want to end the display.
Deactivate the alarm system with the electronic key (emergency
deactivation / workshop mode)
In an emergency, you can deactivate the alarm system or put it into workshop mode
using the electronic key. This means the alarm system will no longer be activated by
the remote control and will remain completely switched off. Deactivation with the
electronic key is possible only if the alarm system was activated for at least
40 seconds (the LED on the base of the electronic key flashes).
➤ Open the vehicle door with the vehicle key.
✓ The alarm system triggers an alarm.
➤ Insert the electronic key in the electronic key base.
✓ The alarm is deactivated and in "workshop mode".
The LED flashes every 16 seconds.
➤ In order to restore the normal function, you must insert the electronic key into the
key holder within 40 seconds after locking with the remote control.
✓ The alarm system can once again be activated and deactivated by your remote
control.
10.3 Setting the sensitivity of the ultrasonic sensors
(fig. 5)
The sensitivity of the ultrasonic sensors is set on the ultrasonic module.
➤ Turn the setting screw (fig. 5 3) on the underside of the ultrasonic module in the
direction of "+" to increase the sensitivity or
➤ ... turn the setting screw of the ultrasonic module in the opposite direction "–" to
reduce the sensitivity.
➤ To deactivate the ultrasonic module, turn the setting screw of the ultrasonic
sensor all the way in the direction "–".
I
NOTE
If the ultrasonic sensors are set too sensitively, the alarm may be
triggered by a hailstorm, for example. For this reason you should not set
the sensitivity too high.
22
MS680
EN