Using The Alarm System - Dometic MAGICSAFE MS 680 Instrucciones De Montaje Y De Uso

Using the alarm system

➤ Wait 8 seconds to remove all programmed devices.
✓ Once all programmed devices have been removed, the LED turns off.
➤ Switch the ignition off.
✓ The siren emits three acoustic signals, and the LED in the base of the electronic
key flashes three times.
10 Using the alarm system
10.1 Activating the alarm system
To activate the alarm system manually, proceed as follows:
➤ Lock the vehicle with your remote control.
✓ The vehicle emits optical signals according to the factory settings.
I
NOTE
After roughly 40 seconds, the alarm system indicates that it is ready to
operate with flashing of the LED in the base of the electronic key.
Activating the alarm system so that the vehicle can remain occupied
You can set the alarm system so that the alarm system does not trigger an alarm – to
spend the night in the vehicle, for example.
To do this, follow the steps below under A or B:
A) Cables for the central locking system are connected (fig. 9 3 and fig. 9 4):
➤ Press button (fig. 3 2) on the additional remote control.
✓ The vehicle locks and the alarm system is activated with deactivated interior
monitoring. (The wireless magnetic contact switches remain active.)
20
MS680
EN