Operation - Tazz 35425 Manual Del Operador

OPERATION

GAS AND OIL QUALITY
To operate the engine, we recommend using Viper® brand 2-cycle
oil to ensure that the engine operates correctly throughout the
life of the engine. Viper® brand two-cycle oil has fuel stabilizer
additive which helps to prevent gasoline from oxidizing and
gumming up the carburetor when the unit is not in use for long
periods of time. Use unleaded regular gas only. It is best to use
premium gasoline that has no ethanol content.
NOTE: Viper® oil can be purchased from our web site at www.
tazzoutdoorproducts.com.
MIXTURE
Run earth auger with a 50:1 ratio.
GAS
1 gallon
2 gallons
5 gallons
MIXING FUEL AND FILLING GAS TANK
MIXING FUEL
1. Fuel must be mixed in a container outside in a well ventilated
area.
2. Fill certified fuel container 1/4 full of recommended fuel.
3. Add recommended amount of 2 cycle oil.
4. Screw container cap on straight and tight.
5. Shake the container to mix fuel and oil.
6. Unscrew gas cap slowly to vent, add the remainder of fuel
requirements.
7. Wipe away any spilled fuel or oil and allow to evaporate before
moving or transporting.
FILLING FUEL TANK
1. Shut-off engine and allow engine to completely cool before
refilling the fuel tank.
2. Move to a well-ventilated area, outdoors, away from flames
and sparks.
3. Clean debris from area around the fuel cap.
4. Loosen fuel cap slowly.
5. Carefully add fuel without spilling.
6. Do not fill fuel tank completely full; allow space for fuel to expand.
7. Immediately replace fuel cap and tighten. Wipe off spilled
fuel and allow to dry before starting engine.
10
OIL RATIO
2.5 ounces 50:1
5 ounces 50:1
13 ounces 50:1
Check for parts online at www.tazzoutdoorproducts.com or call 800-345-6007 M-F 8-5
CAUTION
DO NOT ALTER/MODIFY ENGINE OR AUGER:
NEVER ALTER OR MODIFY THE ENGINE FROM THE
FACTORY. SERIOUS INJURY OR DEATH MAY OCCUR IF
ENGINE IS MODIFIED OR ALTERED.
WHEN WORKING ON OR REPLACING PARTS FOR THE
ENGINE OR AUGER YOU MUST ALWAYS DISCONNECT
THE SPARK PLUG WIRE FROM THE SPARK PLUG AND
KEEP IT AWAY FROM THE SPARK PLUG.
ALWAYS WEAR HEARING
OPERATING ENGINE.
DO NOT START YOUR EARTH AUGER UNTIL YOU HAVE
READ THE PREVIOUS SECTION OF THIS MANUAL. IF
YOU HAVE READ THESE, FOLLOW THE STEPS BELOW
TO START YOUR EARTH AUGER.
NEVER STORE ENGINE WITH GAS IN THE TANK INDOORS.
FUEL AND FUEL VAPORS ARE HIGHLY FLAMMABLE.
NEVER MIX FUEL AND OIL DIRECTLY IN ENGINE GAS
TANK. USE ONLY NON-METAL, PORTABLE FUEL
CONTAINERS APPROVED BY THE UNDERWRITER'S
LABORATORY (U.L.) OR THE AMERICAN SOCIETY FOR
TESTING & MATERIALS (ASTM).
HANDLING AND FILLING THE ENGINE WITH FUEL
MUST ALWAYS BE DONE BY AN ADULT.
ALWAYS HANDLE FUEL IN A WELL VENTILATED AREA,
OUTDOORS, AWAY FROM FLAMES OR SPARKS.
IMPORTANT
THIS ENGINE USES A GAS/OIL MIXTURE. DO NOT RUN ON
STRAIGHT GAS ONLY. THIS WILL VOID THE WARRANTY
AND ENGINE DAMAGE WILL RESULT.
NORMAL OPERATION
1. The clutch will transfer maximum power after about two
hours of normal operation. During this break-in period, clutch
slippage may occur. The clutch should be kept free of oil or
other moisture for efficient operation.
2. Drill holes without placing excessive body weight on the unit.
The auger operates most efficiently with a shaving action
caused by the weight of the unit itself.
3. Never run engine indoors. Exhaust fumes are deadly.
4. Do not use an earth auger in the ice.
Operator's Manual
2-Cycle Earth Auger Powerhead
PROTECTION WHILE