The Safe2Go Car Seat - Mutsy NEXO Manual De Instrucciones

length by sliding the straps over the shoulder belts until both shoul-
der belts properly harness your child. Slide the strap down to make the
belt longer. Move the strap upwards to make the belt shorter. This will
create a loop in the belt. Hold on to the strap and pull the clamps to
take the loop out of the belt again. Attach the shoulder protection to
the belt again on both sides after adjustment by pressing the velcro
together again.
· The back support contains three positions for the shoulder belts. Re-
lease both shoulder belts by inserting the fastening rings at the rear
of the back support through the openings. Look for the fastening ring
through the fabric (v1). Tilt it and push it through the opening. (v2)
· Move the attachment rings through the desired openings so that the
shoulder belts are positioned properly.
· In order to adjust the position of the leg piece, open the upholstery
under the seat by pulling the velcro loose. The fastening ring of the
leg piece is located at the bottom of the seat between the seat and
the elastic. You can tilt the fastening ring with your hand and push it
through the opening to adjust it.
· Regularly check the length and position of the belts and adjust, where
necessary.
Safe2go car seat (up to 13 kg)
· Make sure that the frame has fully been unfolded and the brake blocked
during all actions indicated below.
· The car seat can be combined with the pushchair seat.
Installing the Safe2go adapters to the frame (w)
· The adapter marked with 'R' is placed on the right side of the frame, the
adapter e adapter marked 'L' is placed on the left side.
· Remove the bumper bar and the hood.
· There is an opening at the front of the adapter. Put the opening of the
adapter around the cam (w1) on the frame from the outside.
· Turn the top of the adapter inwards (w2) until it clicks. Check that the
adapter has been attached properly by trying to lift it from the frame.
Place the Safe2go car seat
· Orientate the Safe2go car seat such that it is directed rearwards on the
frame. Hold the Safe2go car seat with the central hinge points of the
support bar directly above the adapters.
· Lower the Safe2go car seat and press solidly into the adapters until you
hear a click. Check that the Safe2go car seat has been placed horizon-
tally and has been attached properly by trying to lift it from the frame.
22