Preliminary Checks - Genius G60 Manual Del Usuario

ENGLISH
4. DESCRIPTION
5
4
3
1

5. PRELIMINARY CHECKS

The door structure must be suitable for automation. In particular,
check that the door dimensions conform to those given in the
technical specifications and that the door is strong enough.
Check the efficiency of the door bearings and joints.
Make sure the door moves smoothly; if necessary, clean the guides
and lubricate them with silicone-based products (do not use
grease).
Check correct balancing.
Remove the door's mechanical closing devices so that the door
is closed by the automatic system.
Check if there is an efficient earth plate for electrical connection
of the operator.
Make sure there is a clearance of at least 35 mm between the
Min. 35mm
7
9
8
10
6 11
2
Fig. 4
Ceiling fixture
Plastic housing
12
Courtesy light
Electronic equipment
Motor
Operator support
Rear connection
Operator fixing bracket
Sliding guide
Drive carriage
Release knob
Door connection bracket
Transmission unit
Front connection and chain adjuster
Front connection bracket
ceiling and the highest sliding point of the door (fig. 4 and 5).
With sectional doors, check that the upper guide roller is in the
horizontal part of the guide when the door is closed (fig. 6).
Min. 35 mm
Fig. 5
14
ENGLISH
15
14
13
Fig. 3
Fig. 6