D- USING YOUR DEEP FREEZER
Loading foodstuff to your product
You can load your foodstuff as permitted in this manual after your product reaches to desired temperature at
empty state. (If your product is a thermometer installed model, you can control internal temperature of your
product from here.)
CAUTION!
Before loading your freezer with foodstuff, run your cooler empty for three (3) hours.
Do not load your product with food over the loading line.
Defrosting
Your product has manual defrost.
If there is excessive frost deposit on the walls of your device, this will lead decrease in the cooling capacity
and increase in energy consumption.
Clean the walls with frost deposit by means of a frost shaver supplied with the device without damaging
the walls.
If the frost deposit and the its thickness is high, place the products inside of your device to another suitable
EN
environment that prevents them to get spoiled.
Unplug your product. Frost deposit generally melts in two (2) hours.
Place a container at water discharge for preventing the melted ice waters to damage the floor.
After defrosting operation, wipe internal walls with a dry cloth to make sure that they are not wet.
Run your device empty again for three (3) hours and wait for it to cool down. Then you can place your
foodstuff in it.
50
D- USING YOUR DEEP FREEZER
Shutting down your product
Transfer the foodstuff inside your product to a convenient place.
Unplug your product. (Picture 29)
If your product will not be used for a long time, apply following considerations;
Clean your product. Otherwise the humidity on the wall may cause darkening of the internal surface.
PICTURE 29
CAUTION!
If your product will be stored at an indoor place after shutdown;
Do not cover it with plastic sheets. Plastic will cause smell and sweating of your product as it does not
breathe. Corrosion may be seen as the result of sweating.
Smell formation may occur in cases where you fail to store your product with the door open.
51
EN