GYS AUTOPULSE M1 Manual Del Usuario página 31

Operating manual
OPTIONAL PUSH-PULL TORCH
Reference number Wire diameter
044111 0.6 > 1.0 mm
046283 0.6 > 1.2 mm
A push-pull torch can be connected to the power source via the socket (I-13). This type of torch allows the use of AlSi wire even in Ø 0.8 mm with a
torch length of 8 m. This torch can be used in all MIG-MAG welding modes.
The Push-Pull torch is detected by simply pulling the trigger.
When using a push-pull torch with potentiometer, the highest control range setting can be set using the interface.
The potentiometer can then range anywhere between 50% and 100% within this setting.
DEFECTS: CAUSES & SOLUTIONS
SYMPTOMS
The flow of the welding wire is not constant.
The reel motor is not working.
Incorrect wire unwinding.
No current or wrong welding current.
The wire jams after passing through the
rollers.
The weld bead is porous.
Excessive sparks.
No gas coming from the torch.
Error while downloading.
Backup error.
Translation of the original
instructions
Length Cooling type
4 m
4 m
POSSIBLE CAUSES
Clogs blocking the opening.
The wire slips in the roller.
One of the rollers is spinning.
The torch cable is twisted.
Reel brake or roller is too tight.
Dirty or damaged wire guide.
Roller pin key is missing.
Reel brake is too tight.
Improper connection of mains plug.
Poor earth connection.
No power.
Crushed wire guide sheath.
Wire jamming in the torch.
No capillary tube.
Wire speed too high.
The gas flow is insufficient.
Gas cylinder empty.
Unsatisfactory gas quality.
Air circulation or wind influence.
Gas nozzle is too clogged.
Bad wire quality.
Condition of the welding surface is too poor
(rusted, etc.).
The gas is not connected.
Arc voltage is too low or too high.
Poor earth connection.
Insufficient gas protection.
Poor gas connection.
The data on the USB stick is incorrect or
corrupted.
You have exceeded the maximum number of
backups.
Air
Air
Clean the contact tube or replace it with non-
stick material.
Reapply the non-stick product.
Check the tightness of the roller screw.
The torch cable should be as straight as
possible.
Loosen the brake and rollers.
Clean or replace.
Reposition the pin in its slot.
Loosen the brake.
Check the plug connection and verify that the
plug is connected to the power supply.
Check the earthing cable (its connection and
the condition of the clamp).
Check the torch trigger.
Check the sheath and torch.
Replace or clean.
Check that the capillary tube is present.
Reduce the wire speed.
Adjustment range from 15 to 20 L / min.
Clean the base metal.
Replace it.
Replace it.
Avoid draughts and protect the welding area.
Clean or replace gas nozzle.
Use a wire suitable for MIG/MAG welding.
Clean the workpiece before welding.
Check that the gas is connected to the power
source's inlet.
See welding settings.
Check and position the earth clamp as close
as possible to the area to be welded.
Adjust the gas flow.
Check the connections of gas inlets.
Check that the solenoid valve is working.
Check your data.
You need to delete some programs.
The number of backups is limited to 500.
AUTOPULSE M1 - M3
SOLUTIONS
31