Servicing And Repair - Barloworld Scientific Stuart SB161-3 Instrucciones De Funcionamiento

Servicing and Repair

This product range does not require any routine
servicing.
Note: There are no internal user
replaceable parts.
In the event of product failure it is recommended
that any repair is only undertaken by suitably
qualified personnel. For advice or to receive a
service manual please contact the Technical
Service Department of Barloworld Scientific Ltd.
Only spare parts supplied by Barloworld Scientific
or its agent should be used. Fitting of non-
approved parts may affect the performance of
the safety features of the instrument.
Note: The magnetic stirrer drive utilises
strong magnets.
If in doubt, please contact the Technical Service
Department of
Barloworld Scientific Ltd.
Stone, Staffordshire ST15 0SA
United Kingdom
Tel: +44 (0) 1785 812121
Fax: +44 (0) 1785 813748
e-mail equipment@barloworld-scientific.com
www.barloworld-scientific.com
Spares
The following spare parts are available from your
laboratory supplier. For a comprehensive parts
list please contact the Technical Service
Department of Barloworld Scientific Ltd quoting
model and serial number.
Description
Control knob
Rubber feet, set of 4
Retort rod,
Catalogue
Number
SB160/CK
SB160/RF
CS10
Warranty
Barloworld Scientific Ltd warrants this instrument
to be free from defects in material and
workmanship, when used under normal
laboratory conditions, for a period of three (3)
years. In the event of a justified claim Barloworld
Scientific will replace any defective component
free of charge.
This warranty does NOT apply if any repair has
been made or attempted other than by
Barloworld Scientific or its agent.
3