Tools And Materials; Technical Information - BOCCHI 2019 0001 Serie Instrucciones De Instalación

Tools and Materials:

Adjustable
Wrench
NOTE: Special tools may be needed to install faucet mounting holes, or water lines, if not already done, please consult a
professional to perform any additional steps to prep the space for the installation of these faucets.
Hardware (included with the faucet):
Included with all BOCCHI Faucets:
• Mounting Hardware: rubber seal (1pc.), stainless steel washer (1 pc.), mounting ring (1 pc.), screws (3 pcs.)
• Retraction Weight (1 pcs.)
• Pullout Hose (1 pc.)
• Supply Hoses (1 pc. hot and 1 pc. cold)
• Optional Stabilizer (1 pc.) to be used if the faucet is installed on a thin and flexible countertop or with a
stainless steel sink
Optional Hardware (not included with the faucet):
Sold separately. Compatible with all BOCCHI Faucets:
• Optional Deck Plate may be used with any BOCCHI Faucet to provide a decorative base to the faucet. All
BOCCHI Deck Plates (2180 0003 XX or 2180 0004 XX) fit all BOCCHI Faucets but are sold separately. Designed
to fit across a standard 8-inch faucet drilling to hide unnecessary holes, or other unsightly marks. All BOCCHI
Deck Plates come with a single center-drilled hole.

Technical Information:

Recommended water pressure= 20 - 75 psi
Recommended hot water temperature = 1200 - 1400 F
Flow rate = 1.75 gpm maximum
Necessary hole size in countertop/sink = 1 3/8 inches
Maximum thickness of countertop/sink = 2 1/2 inches
• Pull-down sprayheads are equipped with 2 check valves for backflow prevention.
• The supply hoses for the faucets are for use with 3/8 inch service stops. If your service stops are of a different
size, purchase adapters at your local home center or plumbing store.
IMPORTANT: It is imperative that you follow all local plumbing codes and standards to assure correct installation
and hot water temperature at the water heater.
IMPORTANT: Shut off water at the service stops before you begin.
CAUTION: Do NOT bend or twist the supply hoses! A gentle
curve of no less than 2 3/4 inch diameter is allowable for space,
however tight bends, kinks, and twisting may result in damage to
the hoses.
2
Phillips Head
Screwdriver
/ Maximum water pressure = 145 psi
/ Maximum hot water temperature = 1600 F
www.BOCCHIUSA.com