Before You Begin - BOCCHI 2019 0001 Serie Instrucciones De Instalación

Before you begin:

• BOCCHI recommends that this faucet be installed by a licensed professional plumber/installer.
• Please read over the entire installation instructions before beginning the installation.
• Images in these instructions are generic and may vary slightly from your exact model.
• Make sure you have all the needed tools and parts to complete the installation. Ensure that the are has
been properly prepped for the preferred installation setting.
• Keep this installation guide and your receipt for proof of purchase and future reference.
• Care and Cleaning Guides and Warranty information for these faucets may be found at www.bocchiusa.com
• All information in these instructions is based on the latest product information available at the time of
publication. BOCCHI reserves the right to make revisions in the design of products without notice, as
specified in the Price Book.
Installation:
• Double check to be certain that the water is shut off at the service stops before you begin.
• If necessary, remove the old faucet.
• Clean the mounting area and surface, and dry thoroughly.
• Insert the new faucet in the mounting hole. NOTE: If you are using an optional deck plate,
install it now. Simply set the deck plate into place over the faucet mounting hole and drop
the faucet through the deck plate hole as you also drop it through the countertop hole.
Once the faucet is securely installed in place, it will hold the deck plate in place.
• If using the stabilizer flange, install it now. Stabilizer
flanges should be used with thin or flexible
countertops, and with stainless steel sinks. The
stabilizer should be installed with the flat triangular
side facing up, and the tube side facing down, then
be slid onto the faucet shaft from underneath the
countertop to help stabilize the faucet from below.
• Slide the mounting hardware onto the shaft of the
faucet from the underside keeping the water supply
lines inside the mounting ring. The order of mounting
hardware should be, starting with the first on, closest
to the underside of the countertop: (1st) rubber seal,
(2nd) stainless steel washer, (3rd) mounting ring.
• Tighten the mounting ring and all parts and insert
the 3 screws provided with the faucet into the 3
corresponding holes on the mounting ring. Tighten
using the Phillips head screwdriver. CAUTION: Do
NOT over tighten or use a power drill to tighten the
screws.
www.BOCCHIUSA.com
Flange
Rubber Seal
Stainless
Steel Washer
Mounting
Ring
With Flange
Without Flange
3