arjo Enterprise ENT-ACC32 Instrucciones De Uso página 4

Always use the correct size Allen (hexagon) key to tighten the screws
– using other tools may result in the screws not being properly
tightened
Undo the hand wheel (5) on the pulley assembly and open the clamp. Position the
pulley assembly on the upright pole, so that the spigot inside the clamp fits into one
of the holes (6). Close the clamp around the pole and tighten the hand wheel firmly.
Use the pulley (7) to support traction cords and weights as required. If necessary,
disable bed functions (tilt, height and backrest angle) using the ACP – refer to the
bed instructions for use.
Make sure the fixing screws and hand wheel are properly
tightened before use
Do not allow traction weights or cords to touch the bed
frame, floor, bedside furniture, etc. when operating the bed
controls
Do not move the bed while traction equipment is in use
unless authorised by a clinically qualified person
Do not exceed the accessory's safe working load of 20kg
WARNING
7
WARNING
2
6
5