Connection To The Water Supply - Gorenje Tiki TC 400-2/S Manual De Uso

Thermometer
Apointing foot with part
WARNING: The appointing foot musst not be used for transport!
Technical characteristics of the heating pump
Refrigerating agent
Connected power
Heating power
Voltage
Heating number
Adjusted water temperature

CONNECTION TO THE WATER SUPPLY

The water heater should be connected to the water supply as indicated by the
colour coded pipes: the cold water supply pipe (below) is coloured blue, while the
hot water outlet pipe (above) is coloured red.
For safety reasons the supply pipe must be fitted with a return safety valve that
prevents the pressure in the tank from exceeding nominal pressure by more than
0.1 MPa. The heating of water in the heater causes the pressure in the tank to
increase to the level set by the safety valve. As the water cannot return to the water
supply system, this can result in dripping from the outflow of the safety valve. The
drip can be piped into the drain by installing a catching unit just below the safety
valve. The drainpipe fitted under the safety valve outflow must be piped down in a
straight vertical line and located in an environment free from the onset of freezing
conditions.
Cutting B-B
Anode
Canal for
palps
R404a
1080 W
3000 W
230 V / 50 Hz
to 3.2
cca. 50 °C
HP- heating pump
PT - heat exchanger
Cutting A-A
41