Gorenje Tiki TC 400-2/S Manual De Uso página 43

OPERATION OF THE HEATING PUMP
After the water tank with heating pump is electrical connected to water supply
(heating) network and .lled with water, the heating pump is connected to power
supply network and ready for operation. Switch the pump on with the main switch.
The heating pump starts operating and operates until the switch-off temperature is
reached (factory set to 55 °C). After switching off, the operation is interrupted until
the water temperature falls by 5 °C (e.g. to 50 °C), when the heating pump starts
operating again.
The user may adjust the switch-off temperature of water to max. 55 °C (thermostat
blocking) or optionally reduce it up to min. (thermostat blocking).
Legend:
1 – Heat pump switch on
2 – Legionella Control switch on
3 – Control lamp - heat pump operation
4 – Control lamp - Legionella Control
switch on
5 – Display
6 – Temperature setting - increase
7 – Temperature setting - reduce
After connecting the heat pump to power supply, the display shows servicing
markings and then the temperature value. If the water temperature in the hot water
tank is lower, the heat pump is automatically switched on (the red signal lamp 3 is
on). To turn the off the operation of the heat pump, press the key 1 (ca. 2 seconds).
The operation of the heat pump is switched off; the display shows the marking
OFF.
CONNECTION TO ALTERNATIVE SOURCES OF HEATING
The heaters with heating pump enable the water for sanitary use to be heated by
alternative sources of energy (e.g. central heating, solar power, ...) by installing
one heat exchangers.
Options for connecting the water heater to various sources of heating are shown in
the drawings below.
43