Start-Up - Cooper Tools Weller WSF 80 D5 Instrucciones Para El Manejo

External input device WCB1 and WCB2 (optional)
The following functions are available when using an external input device:
Offset: The actual temperature of the soldering tip can be changed by + - 40°C by
entering a temperature offset
Setback: Reduction of the setpoint temperature to 150°C /300°F (standby). The setback
period, after which the soldering station switches to the standby mode, can
be adjusted from 0 – 99 minutes. The setback state is indicated by a blinking
display of the actual value. After three setbacks, the AUTO OFF function will be
activated and the soldering tool will switch off (blinking dash on the display).
The setback state or AUTO OFF ends after pressing a key or the finger switch.
At this time the setpoint will be displayed briefly.
Lock: Locking of the setpoint temperature and temperature window. No changes
can be made to the soldering station settings after locking.
°C / °F: Switching the temperature display from °C to °F and vice versa. Pressing the
"Down" key when switching the unit on will show the current temperature
version.
Window: Adjusting the temperature window. If the actual temperature is within the
temperature window, the floating contact (optocoupler output) will be enabled.
Cal: Factory setting FSE (reset of all adjusted values to 0, temperature setpoint
value: 350°C/660°F
PC interface: RS232 (WCB2 only)
Temp.gauge: Integrated temperature gauge for thermocouple Type K (WCB2 only)
Maintenance
If the feed rate is irregular, the drive wheel can be cleaned with a brass brush. First remove
the control unit from the feed unit. Push back the cover of the feed unit to access the feed
unit. Lift the drive wheel and clean.
WSF80D58 33
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com

2. Start-up

Establish the electrical connection between the feed unit and the control unit. Insert plug (11)
into socket (6).
Connect the soldering iron connections to the control unit and feed unit. Insert the electrical
connecting plug for the soldering iron into the 7-pin socket (8) of the control unit, and lock
into place. Fully insert the wire lead into the connection element (12) of the feed unit and
fasten with the clamping screw (17).
Place the soldering iron in the storage tray.
Verify the correct system voltage and connect the control unit to the mains (13). Switch on
the unit (1).
Install solder roll.
Remove knurled nut (19) on the solder roll holder. Place the solder roll on the shaft so that the
wire unrolls downwards. Secure the roll with the knurled nut and push the end of the wire
into the inlet port (18).
Pressing the "UP" and "DOWN" keys simultaneously will cause the drive to catch the solder
wire and transport the wire at maximum speed. Continue to advance the solder wire until it
appears at the soldering iron nozzle (22).
In the event that the solder wire is not caught by the drive, the cover of the feed unit can be
pushed back to access the drive unit. Therefore turn both locking pins (10) counter clock
wise (ccw) approx. 90° until release.
Carry out adjustments to the units as described in the section "Operation and settings".
04.04.2002, 9:26 Uhr
33