Product Description; Technical Data; Installation And Assembly - Dea LOOK Instrucciones De Uso

2 PRODUCT DESCRIPTION

Models and contents of the package
LOOK identifies a family of operators with different characteristics as regards the supply voltage, the reversibility and the presence
of the encoder.
LOOK is designed for installation in residential swing gates, is composed primarily of a mechanical gear motor that drives the lead
screw fastened to the front attachment by means of the adjustment screw.
LOOK is completed by a set of accessories listed in the "PRODUCT ACCESSORIES" table (page 43).
Inspect the "Contents of the Package" (Pic. 1) and compare it with your product for useful consultation during assembly.
Transport
LOOK is always delivered packed in boxes that provide adequate protection to the product, however, pay attention to all infor-
mation that may be provided on the same box for storage and handling.

3 TECHNICAL DATA

Motor power supply voltage (V)
Absorbed power (W)
Max torque (Nm)
Duty cycle (cycles/hour)
Maximum n° of operations in 24 hour
Built-in capacitor (µF)
Operating temperature range (°C)
Motor thermal protection (°C)
Opening time 90° (s)
Weight of product with package (Kg)
Protection degree

4 INSTALLATION AND ASSEMBLY

4.1 For a satisfactory installation of the product is important to:
• Verify that the gate complies with the legal requirements and then define the complete project of the installation;
• Verify that the gate is well balanced and that it has no points of friction in opening and closing;
• Identify an area that allows a smooth and safe manual operation of the operator;
• Verify that the operator bulk (Pic. 2) is compatible with the area chosen for the fitting (Pic. 3);
• Use the length/weight graphic and the provided installations dimensions (Pic. 4) evaluating whether you prefer a 90° or higher
opening (Pic. 4).
4.2 Defined and satisfied these prerequisites, proceed to the assembly:
• Fix the rear junction to the pillar bu welding (Pic. 5);
• Fix the front junction to the gate by welding (Pic. 6);
• Keeping the motor in a horizontal position, mount it first to the front bracket, then to the rear bracket (Pic. 7) ensuring that in-
stallation dimensions shown in Picture 4 are respected.
WARNING In order to make the structure sufficiently strong, reinforcement plates to be fixed to attachments may be necessary.
WARNING Grease pins before assembly.
4.3 How to unlock the operator
• Turn the cap placed on the back of LOOK in order to discover the underlying shaped hole;
• Insert the release key inside the shaped hole paying attention to the direction of insertion (Pic. 8.a);
• Rotate 90 degrees (counterclockwise to unlock, clockwise to lock ) the release key (Pic. 8.b).
WARNING Remember to protect the lock with the respective cover so that the operator is protected by water or powder (even
when it remains unlocked for a long time).
WARNING During this operation gate may perform uncontrolled movements: operate with extra care so to avoid any risk.
8
351/SC 355/SC
353/SC -
- 352/SC - - 356/SC -
354/SC
351EN/SC 355EN/SC
230 V ~ ±10% (50/60 Hz)
300
1650
22
400
8
150
16 12,5 17
9 9,5 9
371/SC -
357/SC -
371EN/SC - 374/SC -
358/SC
- 372/SC 373EN/SC
24 V
60
1200 1000
40
700
10
-20÷50 °C
13,5 14
9,5
IP24
373/SC
371/SCE
50
500
10
200
/
/
15 15
9