ProMed 520 Manual Del Usuario página 22

o
PeratinG tHe unit
DE
into the grinding head holder without you having to use
excessive force. To remove the grinding head, please switch
US
the unit off using the switch (D) or position the rotation
direction switch (F) onto "standby" (mid-position). Remove
FR
the grinding head by simply pulling it straight out.
D. To switch the unit on, push the toggle switch (D) labeled
IT
"Power" onto the "ON" position (the green switch must light
up). To switch the unit off, push the same switch onto the
ES
"OFF" position.
E. Adjusting the speed:
NL
The desired speed is set using the large rotary knob (E).
RU
F. Adjusting the direction of rotation:
To protect the motor and ball bearings, you should set the
PL
rotating speed to "0" or put the unit in "standby" for a
short moment before you change the direction of rotation.
SE
Clockwise:
To switch the unit into clockwise rotation, push the toggle
FI
switch labeled "Direction" (F) onto the
Counterclockwise:
To switch the unit into counterclockwise rotation, push the
toggle switch labeled "Direction" (F) onto the
G. Standby mode:
When the toggle switch (F) is positioned in the middle, the unit
is in standby and the motor stops, e.g., to stop the grinding
head for a short moment without altering the selected speed.
However, to completely switch the unit off, please place the
ON/OFF switch (D) onto the "OFF" position.
H. Before the first use, make sure that you let the handpiece run
for about 30 minutes at approx. 8.000 rpm (knob (E) 1/3
turned up). This is necessary to bed in the carbon brushes
of the motor.
" position.
"
position.
"
"