Publicidad
Idiomas disponibles
Idiomas disponibles
• Follow the mounting instructions carefully. Fasten the tool to the
saw mounting brackets securely as instructed.
• DO NOT modify or use stand for operations for which it is
unintended.
• DO NOT use the stand on uneven surfaces. DO NOT use the
stand with the legs folded and stand sitting on the ground. The
stand is designed to be used on a flat, stable surface.
ASSEMBLY
Attaching the Wheels and Axle
1. Attach the axle (A) to
the leg support (B) by
aligning
the
pre-drilled
holes. Ensure the long end
of the axle is to the rear of
the stand as shown. Secure
axle to leg support using
two carriage bolts, washers
and lock nuts provided.
2. Place the wheels (C) on
the axle and secure with
washers and lock nuts as
shown. Tighten wheel and
axle nuts securely.
Attaching the
Kickstand
Insert the tube plugs (O) into the end of the kickstand tube (N). The
groove in the tube plug should be facing down as shown. Be sure
that the holes (P) in the tube plugs are in line with the holes (Q) in
the kickstand tube before inserting the tube plugs.
B
A
Insert the kickstand tube (N) through
the holes in the leg support (B) on
the wheel-axle side of the stand.
Be sure the kickstand is pointing
up when the stand is an upright
position. Secure the kickstand to
the beams (I) with the four M6
screws provided as shown (below,
left).
The hex wrench may be stored in the end of the tube plug as shown
for future use.
B
N
Attaching the
Rubber Bumpers
Attach
the
two
rubber
bumpers
(M)
to
the
handle side leg support as
shown using the M4 screws
and lock nuts provided.
3
Q
N
P
O
M
Publicidad
