Dsp Configuration - Monitor Audio IA150-2 Manual Del Usuario

Control Zone – Select A, B, C, D, ... (Number of
groups = number of output channels). This groups
the settings Output Volume, Turn On Volume and
Mute across channels which have the same Control
Zone selected. For controlling several channels as
a single zone.
Amp Mode – Select between Stereo and Bridged
Mode. Also used to select 70V mode on IA800-2C.
Output Volume
Channel – Select output channel to edit. When
a channel is selected from a drop down menu its
equivalent channels will also show on the other
drop down as above. The following options control
the selected channel output:
- Output Volume - this is linked to the control dial
on the front. Adjusting the dial on the front changes
the value on the web page (once refreshed). the
dial will not change when adjusted on the web
page.
- Turn On Volume
- Mute
Control Zone – Select Control Zone. The following
options control the selected zone output:
- Maximum Volume
- Gain Offset
Output Source
Channel – Select output channel to edit routing.
When a channel is selected from a drop down
menu its equivalent channels will also show on the
other drop down as above.
Source 1 – Select Primary input source to be
routed to selected channel.
Primary source is always stereo linked so for
example if 1L is selected for the left channel, 1R will
automatically be selected for the right channel
Source 2 – Select secondary input source to be
routed to selected channel.
Secondary source can be individually selected and
doesn't have to be stereo linked.
Source Select – Select between Priority Source 2,
Source 1 Only, or MIX.
By doing this either Source 1, Source 2 or a MIX
(of source 1 and 2) will be routed to the selected
output channel. Default: Source 1.
10

DSP Configuration

On the DSP configuration tab final adjustments can
be made to the sound using a 10 band parametric
EQ, these can then be saved as presets, which can
be exported and imported.
to one of the other pages.
Installation Amplifiers
NOTE: Some changes made in the web
portal will not be visible until the page
is manually refreshed or you navigate