Feet
Every amplifier model is supplied with four rubber
feet for when used out of a rack. To attach the feet
simply screw them into the four threaded inserts on
the base of the amplifier.
Rack Mounting your Amplifier
Every amplifier model is supplied with rack bracket
fixings for mounting the amplifier in standard 19"
racks. To fit the brackets, simply remove the 4
screws on each side of the amplifier towards the
front. Place the brackets over the holes that have
been revealed and use the same screws to attach
the brackets.
Powering the Amplifier
All models are supplied with an IEC mains cable.
Each time the amplifier's mains cable is initially
plugged in and the power switch is turned ON, all
channel outputs are disconnected for approximately
12 seconds and all Channel Indicator LEDs will
illuminate briefly while the amp boots up.
NOTE: Do not switch on the power at
the wall outlet until all system
connections have been made.
Connecting to a Network
NOTE: This section applies to
'Connect' models only.
1.
Connect the amplifier to a network switch
using an ethernet cable. Make sure the
computer and amplifier are on the same
network.
2.
Turn on the amplifier.
3.
The amplifier will be issued an IP address by
the DHCP Server.
4.
Run an IP address finding application such as
'Advanced IP Scanner' (Windows only), which
is available for free download from here:
https:/ / www.advanced-ip-scanner.com
5.
Launch 'Advanced IP Scanner' (or a preferred
application) and enter your networks IP range
(managed by your router) into the search bar
at the top. Click on Scan to search.
6.
The IP address of the amplifier in the list will
have a drop down option that when double
clicked will take you to the amplifier's web
setup .
Alternatively, all network IP addresses will be
accessible from your Router configuration
page.
Once the amplifier's IP address is known it can
be entered into a web browser of your choice
to open access the web portal.
monitoraudio.com
7