Safety Switch-Off - Teka FGKST 58 Serie Instrucciones Para El Uso Y Montaje

When can Pot Recognition be switched off?
1. When using non-metallic pots.
2. For pots which, because of their size or material, switch on the outer element in the case
of multiple circuit cooking zones without sufficiently covering them.
For safety reasons, turn off the cooking zone after use by means of the Touch-Control, so that the shifting of
pots or setting down of metal objects does not accidentally activate a cooking zone while PR is still turned on.
Timer
The timer can be used to automatically switch off a cooking zone after a pre-set time of between 1 and 99 minutes.
The required cooking zone must be activated, stand-by dot
means of the minus or plus keys
required cooking time between 1 and 99 minutes by means of the Minus or Plus keys
of the selected cooking zone lights up.
The selected cooking time can be altered at any time. Activate the relevant cooking zone, press timer key
change the cooking time by means of the Minus or Plus keys
When the pre-set cooking time has finished, the cooking zone switches off automatically and an acoustic signal
sounds for two minutes. This can be switched off by pressing any key.
If you want to switch the timer off beforehand, press cooking zone key
now be used to set the timer to "00", or alternatively this can be done by the simultaneous pressing of the Minus
"
and the Plus keys + .
The timer can also be used as an egg timer when none of the cooking zones are activated. In this case, no cooking
zone should be activated when the timer

Safety switch-off

Continuous operation of each individual cooking zone is
temporally limited by a safety shut-off which switches off the
cooking zone in accordance with the selected cooking level
after a specified time interval. The intervention times of this
safety device are included in the attached time table. When
the safety switch-off has switched off the touch control system,
a "0" is shown in the cooking level display
is still any residual heat left. Pressing the On/Off key
makes the control system ready for operation again.
If more than one key is pressed simultaneously - with the
exception of the Minus and Plus keys - the control system will
not accept this as a valid command. If one or more keys are
activated for longer than 30 seconds, for example by boiling
over or the weight for a pan, the control system assumes that
there is an error and switches off automatically. If key
operation continues, a constant acoustic signal sounds.
223279
"
/ . Then press timer key
#
is being set (the stand-by dot cooking zone

, or an "H" if there
$

lights up. Select a cooking level from 1 to 9 by
#
. The timer display
"
/ .
!
and timer key
Table of times
MOT = maximum operating time,
in hours
Cooking level
1
2
3
4
5
6
7
8
9
GB
shows "00". Select the
"
/ . The control lamp
#
and
# "
. The Minus key can

does not light up).
MOT (h)
6
6
5
5
4
1.5
1.5
1.5
1.5
15