Using The Touch Screen - Remington HC5960 Manual Del Usuario

ENGLISH
, WARNING
• The appliance can not be operated in corded mode while connected to a PC
via the USB port.
, CORDLESS USE
• When the unit is switched on and fully charged, the product can be used in
cordless mode for 50 minutes.
F INSTRUCTIONS FOR USE
• Turn the product on by sliding the 3 position slide switch down to the
middle position. This will turn the LCD display on and enable height
adjustments and boost adjustments to be made.
• Use the hair clipper without a comb attached for trimming hair close to the
skin. This will trim hair to 1mm. Holding the blades perpendicular to the skin
will trim hair to 0.5mm.
, ADJUSTING THE TRIM INCREMENT LENGTH
• First select which hair comb, stubble comb, short length comb or long
length comb for the length range desired.
• Stubble comb (1.5mm, #0) short length comb (3 – 23mm, #1 – 8), long length
comb (22 – 42mm, #7 – 14).
• Note: If using the stubble comb, once the comb is attached, please press the
mode button until it cycles to Range D. Once this is reached 1.5mm should
be displayed on the LCD display. Please note that the stubble comb is a fixed
comb and will not move up and down when pressing the increment button.
• For the long length comb the increments can only be made in 0.5mm. To set
this press the mode button until Range C is displayed on the LCD screen.
• For the short length comb there are 2 increment settings. Your clipper can
be adjusted in either 0.1mm or 0.5mm increments. To switch between these,
press the mode button. Range A 0-1mm, Range B 0-5mm.
• Note: If a red warning light is visible through the comb when installed, this is
indication that the comb selection switch is on the wrong setting.

, USING THE TOUCH SCREEN

• The motorised, short or long length comb can be adjusted to give you many
different trim lengths, simply by pressing the arrows on the touch screen.
Press and hold the arrow up to increase the cutting length and down to
decrease it. The comb will move to reach each setting, the length will change
slowly and then speeds up as you hold the up/down arrow, and the setting
number will appear on the digital display
All manuals and user guides at all-guides.com
5