Fitting Instructions - bort medical 054 300 Manual De Instrucciones

EN
– no re-use – this medical aid is intended for treating one patient
– whilst wearing the brace, please neither use any creams nor ointments on our
around it as they can destroy the material

Fitting instructions

Preparation for putting the BORT tibialis anterior muscle brace on:
The tibialis anterior muscle brace can be worn directly on the skin and over a thin
sock. It's best to put the brace on when sitting.
1. Open all the tibialis anterior muscle brace Velcro fasteners and pull the brace
over your foot.
2. Grasp the finger loop attached to the reverse side of the tibialis anterior muscle
brace on the upper material edge and pull the tibialis anterior muscle brace
upwards over the heel.
Closing the Velcro fasteners and attaching the restraints:
Before closing the Velcro constraints, please observe that the tibialis anterior muscle
brace is correctly positioned on the foot. The tibialis anterior muscle brace must be
correctly placed on the heel. For an effective course of the restraint, the seams must
be central on the instep and in the heel area.
Important: During the entire following attachment process for the tibialis anterior
muscle brace, the foot and heel remain on the floor!
1
Place your foot on the floor. Place restraints A and B on the outer side and
restraint C on the inner side of the foot on the floor.
2
Then close the Velcro fasteners on the lower leg in the following
order:
– Firstly, the lower of the three fasteners.
– In the next step, the fastener on the upper material edge.
– Finally the fastener positioned in the middle.
10