Horizon Global 76517 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
Access hole
j k
l
m
1. Remove underbody panel – Using an M10 socket remove 3 plastic nut from the forward edge of the underbody panel, using a T25 remove 4 screws
form the rearward edge of the underbody panel. Return to vehicle owner.
2. Remove excess caulk – Using a knife or scraper remove excess caulk or undercoating from the vehicle frame in the area of the hitch install. Make
sure that the M12 weldnuts are free from rust / debris.
3. Fishwire bolts – Using the fishwire method in figure 2, install the 1/2" carriage bolts and spacers into the vehicle frame and through the rearmost
attachment holes, leave fishwires attached. Installer may need to enlarge the access hole and the attachment hole in vehicle frame to accommodate
the ½" bolt
4. Install hitch – Raise the hitch into position, aligning the slots in the hitch with the attachment holes in the vehicle frame. Loosely install the supplied
M12 bolts and conical washers (teeth side toward hitch). Loosely install the supplied conical washers (teeth side toward hitch) and nuts onto the
carriage bolts and spacers installed earlier. May need to trim vehicle fascia in area of hitch bracket.
5. Torque fasteners - Tighten all ½" GR8 fasteners with torque wrench to 110Lb.-Ft. (149 N*M) and all M12 fasteners to 68Lb.-Ft. (92 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2021 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 76517, 84517, CQT76517
Weldnut
Fasteners typical both sides
Figure 1
Frame rail
Access
Hole
Fishwire
example
⑥
l
⑤
Sheet 3 of 15
Fastener Kit: 76517F
① Qty. (2) Carriage Bolt
½-13x1 ¾ " GR8
② Qty. (2) Spacer ¼ "x 1"x 2"
Qty. (4) Conical washer 1/2"
l
Qty. (2) Hex nut
m
1/2'', GR2H
Qty. (2) Hex Bolt
n
M12 X 1.5 X 40mm CL10.9
Qty. (2) Pullwire 1/2''– 13
o
Conical Washer
Against hitch
76517NP 8-18-21
Teeth side
Rev. B