Emerson Blade Select Serie Manual Del Usuario página 19

8. Wall Control Installation
8.4
Before installing Wall Control, place Wall Control in "OFF"
mode by pushing "ON/OFF" Switch to the "OFF" position.
8.5
Connect One Black Wire of Wall Control to the "hot" Wire.
Securely connect Wires with Wire Connector supplied
(Figure 28).
8.6
Connect One Black Wire of Wall Switch to the "load"
(black) Wire in Wall Box. Securely connect Wires with Wire
Connector supplied.
8.7
Screw Wall Control into Wall Box using the supplied
Screws. Leave Wall Control in "OFF" mode until Fan
installation is completed.
WARNING
!
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
8.8
The Wall Control is supplied with a White, Ivory, and
Almond Color Switch Covers. Choose the finish that best
suits your needs and snap the Cover onto the Wall Control
(Figure 28).
8.9
Install Decorator Wall Plate using the Two Screws
provided with Wall Plate. Leave Wall Control in "OFF"
mode until Fan installation is completed (Figure 28).
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
(Continued)
SCREWS (2)
SWITCH COVER
DECORATIVE WALL PLATE
Figure 28
19
SW605 FAN/LIGHT
WALL BOX
WALL CONTROL
NEUTRAL
WIRES