Emerson Blade Select Serie Manual Del Usuario página 7

3. Ceiling Fan Assembly
3.7
Route the Two Motor Leads through the Hanger Ball
(Figure 7).
Reinstall the Hanger Ball on the Downrod as follows:
Position the Pin through the Two Holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
Groove in the top of the Hanger Ball (Figure 7).
Pull the Hanger Ball up tight against the Pin and securely
retighten the Phillips Head Screw in the Hanger Ball
(Figure 7).
A loose Phillips Head Screw could create Fan wobble.
3.8
The Fan comes with Black and White Leads that are
80" long.
Measure up approximately 6 to 9-inches above top of
Hanger Ball/4.5" Downrod Assembly (Figure 8).
Cut off excess Leads and strip back insulation 1/2-inch
from end of Leads.
(Continued)
4.5" DOWNROD
PHILLIPS HEAD
SET SCREW
Figure 7
1/2-INCH
6 TO 9
INCHES
Figure 8
7
PIN
HANGER BALL
BLACK WIRE
WHITE WIRE
HANGER BALL