AIPTEK USBVID 044e&PID 3001 Manual página 16

2. Cannot discover services on an un-paired remote:
The remote device may not be powered up or may be out of
range.
Be sure to restart your computer after installing the software.
Verify that the remote device is powered up.
Verify that the remote device is in the connectable mode ("Bluetooth
Configuration" panel > "Accessibility" tab).
Perform a Search for Devices to verify that the device is within range.
3. Dial-Up Networking service does not start:
The Dial-Up Networking service will not start unless a properly
configured modem is attached to the server.
Verify that the modem is usable as a device on the computer to which it
is attached.
In the "Bluetooth Configuration" panel, on the "Local Services" tab,
double-click the "Dial-up Networking" service.
Click the down arrow in the "Modem" field and select the modem that will
be used to dial out.
Click "OK".
Click "OK" to close the "Bluetooth Configuration" panel.
4. How do I determine the Bluetooth device address (BDA) of
my hardware device?
In the "Bluetooth Configuration" panel, on the "Hardware" tab, in
the "Devices" section, select the device for which you want to
determine the address. In the "Device Properties" section, the
fourth entry, "Device Address", is the BDA of the selected
Bluetooth device.
5. How do I determine the version number of the Bluetooth
specification that the host controller interface (HCI) complies
with?
In the "Bluetooth Configuration" panel, on the "Hardware" tab, in
the "Device Properties" section, the fifth entry provides Bluetooth
specification compliance information for the Host Controller
Interface.
The sixth entry contains the specification revision information for
the Host Controller Interface, if appropriate.
UK
UK UK