Vinten Vector 750 Manual Del Usuario página 15

English
The pan brake is adjusted by turning the pin (4.3). To gain access to the pin it is necessary to remove the
payload from the head, remove the head from its mounting and remove a cover plate (4.1) from the
underside of the head. To adjust the pan brake, proceed as follows:
WARNING!
Remove the payload from the head.
Remove the head from its mounting.
On the underside of the head, remove three screws (4.2) securing cover plate (4.1).
Operate the pan brake lever (4) from the OFF to the ON position.
If brake pressure is not felt after approximately one-third of the lever travel, turn the pin (4.3)
clockwise until this is achieved.
Operate the pan brake lever (4) to the OFF position and ensure that the head is free to rotate.
Refit cover plate (4.1) and secure with three screws (4.2).
14
Remove the payload before adjusting the pan brake.