Maintenance And Inspection; Service And Repairs - Metabo HPT NT 50A5 Instrucciones Y Manual De Seguridad

NOTE: The information contained in this Manual is designed to assist you in the safe maintenance of the Nailer.
Some illustrations in this Manual may show details or attachments that diff er from those on your own Nailer.

MAINTENANCE AND INSPECTION

Read section titled "SAFETY" (pages 3 – 7).
● Disconnect air hose and remove all nails
from Nailer when:
1) doing maintenance and inspection; and
2) clearing a jam.
1. Clearing a jam
Remove a jammed nail in the following order:
1 DISCONNECT AIR HOSE.
2 Remove all nails.
3 Release the lock lever and open guide plate.
4 Remove the jammed nail with a slotted-head
screwdriver.
5 Close guide plate and latch.
6 In case of frequent jam, contact a metabo HPT
authorized service center.
3
Lock lever
3
Guide plate
Guide plate
MAINTENANCE
WARNING
1 Disconnect
air hose
2. Storing
○ When not in use for an extended period, apply a thin
coat of the lubricant to the steel parts to avoid rust.
○ Do not store the Nailer in a cold weather environment.
Keep the Nailer in a warm area.
○ When not in use, the Nailer should be stored in a
warm and dry place.
Keep out of reach of children.
3. WARNING LABEL
Change the WARNING LABEL if missing or
damaged.
A new WARNING LABEL is available from a
metabo HPT authorized service center.
Warning
label
4. Maintenance chart (See page 20)
5. Operator troubleshooting (See page 21)

SERVICE AND REPAIRS

● Only service
metabo HPT, distributor or employer shall
repair the Nailer.
● Use only parts supplied or recommended by
metabo HPT for repair.
All quality Nailers will eventually require servicing or
replacement of parts because of wear from normal use.
NOTE: Specifi cations are subject to change without any
obligation on the part of metabo HPT.
English
WARNING
personnel trained by
19