Hints And Precautions; What To Do If - Rowenta SLIMLINE+ RH7111IA Manual De Instrucciones

HINTS AND PRECAUTIONS

Before each use the supply cord should be completely unwound.
Do not allow it to become trapped or be pulled over sharp edges.
Do not move the vacuum cleaner by pulling its cord, the appliance must be moved by its carrying
handle.
Never lift the appliance by its cord.
If you use an extension cord, make sure that it is in perfect condition and appropriate to the
power rating of your appliance.
Never unplug the appliance by pulling on the cord.
Stop and unplug the appliance after each use.
Only use original Rowenta accessories.
Check that all the filters are properly in place.
Never turn the appliance on without a dustbag and filters.
If you encounter any difficulties in obtaining dustbags and filters for this appliance, please
contact Rowenta Helpline:
0845 602 1454 - UK
or visit our web site : www.rowenta.uk.co

WHAT TO DO IF...

IMPORTANT
As soon as your vacuum cleaner starts to malfunction, and before performing any
checks: stop the appliance by pressing the start/stop switch and unplug it.
Your vacuum cleaner will not start or does not suck.
• The appliance is not connected:
• Either a tool or the tube is blocked:
• The lid was not closed properly:
Your vacuum cleaner's suction power is defective, noisy, whistles.
• A tool or the hose is partially blocked:
• The dustbag is full or blocked with fine dusts:
• A foam filter and/or the micro-active filter are saturated:
micro-active filter.
• The power control* is in the min. position:
when vacuuming delicate fabrics).
• The nozzle is difficult to remove:
The dustbag full indicator* remains lit.
• The bag is full: replace the bag.
If a problem persists, take the appliance to the nearest Rowenta Authorised Service Centre.
See the list of Rowenta Authorised Service Centres or contact the Rowenta Consumer Service:
0 845 602 1454 - UK / (01) 4751947 - IRELAND
* According to model
(01) 4751947 - IRELAND
check that the appliance is correctly plugged in.
unblock the tool or the tube.
check that the bag is properly installed and close the lid again.
unblock the tool or the tube.
replace the dustbag.
increase power using the power control* (except
reduce its power with the cursor of the power control.*
12
clean the foam filters and replace the
GB