Asus ROG Strix Carry Manual De Instrucciones página 5

Pairing your gaming mouse via Bluetooth
1. Set the connection switch to the Bluetooth connection mode.
2. Set up your PC to begin pairing. Click on Start > Control Panel > Devices and Printers, then
click on Add a device and select ROG STRIX CARRY to begin pairing.
NOTE: The steps to set up your PC are the same for both Windows
3. Press and hold the Left button, Right button, and DPI button for approximately 3 seconds to
start pairing. Once the LED indicator starts to blink blue you may release the buttons.
4. Once your gaming mouse has been successfully paired, the LED indicator on your gaming mouse
will light up blue for 3 seconds.
IMPORTANT! If you encounter problems reconnecting your mouse after it has already been
paired, remove the device from the device list, then follow steps 1 - 4 to reconnect it.
NOTE: To pair your gaming mouse to a different device, repeat step 3. This will reset the
Bluetooth pairing and allow you to pair your gaming mouse to a different device.
Updating your gaming mouse and dongle
1. Connect the USB dongle to your computer's USB port, then set your gaming mouse to the RF 2.4G
Wireless mode .
2. Launch ROG Armoury, then update the firmware of your gaming mouse. Please refer to the ROG
Armoury manual for more details on updating firmware.
NOTE: The LED indicator will blink red while the firmware is updating.
Replacing the switches
NOTE: Refer to www.asus.com for the list of compatible switches.
If you want to replace the switches, follow the steps below:
IMPORTANT!
• Ensure to install the switch with its button facing the front of the mouse.
• Ensure that the switches are seated properly on the switch sockets.
ROG STRIX CARRY Gaming Mouse
® ®
7 and Windows 10.
5