Mounting; Electrical Installation - SICK GTE2 Flat Instrucciones De Uso

5

MOUNTING

5 Mounting
6

Electrical installation

6
LED indicator green: supply voltage active
1
LED indicator yellow: status of received light beam
2
Mount the sensor using a suitable mounting bracket (see the SICK range of acces‐
sories).
Note the sensor's maximum permissible tightening torque of 0.1 Nm.
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
– Plug connection: note pin assignment: when the lid is open, the male connector
can be swiveled horizontally and vertically.
– Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established.
Explanation of the connection diagram (Tables pin assignment):
Q = switching outputs
n. c. = not connected
DC: 10 ... 30 V DC
Table 1: Pin assignment
1
2
3
4
> 0 V) once all electrical connec‐
V
BN + (L+)
- -
BU - (M)
BK Q
BK: 0.1 mm , AWG30
2
BU+BN: 0.127 mm 2 , AWG28
= 0 V). The following informa‐
V
+ (L+)
-
- (M)
Q
2 4
1 3
8025415 | SICK
Subject to change without notice