Proper use
WARNING
The appliance is not suitable for vacuuming
dust which endangers health.
– This disposal system is intended for the
low-dust disposal of dry or slightly moist
vacuumed material while using a waste
hose that can be cut to length.
– This appliance is suited for commercial
and industrial use, e.g. in storage and
assembly areas and on production ma-
chines.
– The appliance is not approved for crane
loading.
Device elements
1 Power cord
2 Nameplate
3 Filter dedusting
4 Flat fold filter
5 Suction head
6 Handle of the suction head
7 Left unlocking of the placement me-
chanics
8 Tin tub
9 Disposal system
10 Sheathed cable
11 Right unlocking of the placement me-
chanics
12 Handle of the disposal system
13 Suction head lock
14 Waste hose
15 Steering roller of the chassis with park-
ing brake
16 Floor nozzle holder
17 Chassis
18 Drain pan
19 Suction support
20 Holder for suction pipe
21 Intermediate ring
22 Rotating knob
23 Filter cover
24 Cable clamp
25 Push handle
Bring the appliance to working position
- secure it, if required, with parking
brakes.
Insert the suction hose (not included)
into the suction hose connection.
Ensure that the disposal system has
been inserted properly.
Attach the desired accessories (not in-
cluded).
Inserting the waste hose
Remove all 4 loops of the waste hose
(length: 22 m).
Illustration
Open the intake by a rotation to the left
and pull it out towards the bottom.
Insert the waste hose as shown in the il-
lustration.
Insert the intake and lock it by clockwise
rotation.
Illustration
Pull down the waste hose 40-50 cm.
Close the end of the waste hose by
means of a cable tie.
ATTENTION
The flat pleated filter must always be in
place while vacuuming.
– 2
EN
Start up
Operation
Rotating knob
– Appliance ON
– Filter dedusting OFF
– Appliance OFF
– Appliance ON
– Filter dedusting ON
13