Mitsubishi Electric PAR-W21MAA Manual De Instrucciones página 3

Keep hazardous materials away from this equipment.
Do not install this equipment in locations where there is risk of
combustible gas leakage. The presence of combustible gas may result
in explosion or fire.
Do not wash this equipment with water.
Washing with water may result in electric shock or equipment failure.
Do not touch buttons when hands are wet.
Doing so may result in electric shock or equipment failure.
Do not use this equipment for purposes for which it was not
intended.
This equipment is for use with CITY MULTI R410A SERIES HOT
WATER SUPPLY, AIR TO WATER, and FLOW TEMP. CONTROLLER
Remote Controller. Please do not use it with any other systems, or for
any other purpose, as such usage may result in improper operation.
Do not spray insect repellant or combustible substances on the
equipment.
Keep combustible sprays and substances away from this equipment,
and never spray them directly onto this equipment. Contact with or
proximity to such substances poses risk of explosion or fire.
Do not use this equipment in improper environments.
Do not use in areas where there may be large quantities of oil (machine
oil, etc.), exhaust gas, or sulfide gas. Such environments may degrade
the performance or cause equipment failure.
CAUTION
Do not use sharp-tipped objects to press the buttons.
Use of sharp tips may lead to electric shock or equipment failure.
Do not use under extreme temperatures.
Use only when ambient temperature is within the limits indicated in the
instructions. (If the instructions do not indicate limits, use only at
temperatures between 0°C (32°F) and 40°C (104°F).) Use of this
equipment at temperatures outside of this range may result in major
equipment failure.
Do not pull or twist the communication cables.
Pulling or twisting a cable may result in fire or equipment failure.
Do not disassemble.
Attempted disassembly may result in injury from contact with internal
parts, or may lead to fire or equipment failure.
Do not wipe this equipment with benzene, paint thinner, or
chemical cleaning cloths.
These substances may cause discoloration or equipment failure. If the
equipment becomes noticeably dirty, clean it with a wrung-out cloth that
has been moistened with water-diluted neutral solvent, and then wipe it
with a dry cloth.
– 3 –