This section explains how to set and use the timer. You can use Function Selection of remote controller to select which of three types of timer to use: 1 Weekly timer, 2 Simple

timer, or 3 Auto Off timer.

For information about how to set the Function Selection of remote controller, refer to section 6, item [4]-3 (3).

1 Using the Weekly Timer

The weekly timer can be used to set up to six operations for each day of the week.

• Each operation may consist of any of the following: ON/OFF time together with a temperature setting, or ON/OFF time only, or temperature setting only.

• When the current time reaches a time set at this timer, the unit carries out the action set by the timer.

Time setting resolution for this timer is 1 minute.

Note:

*1 Weekly Timer/Simple Timer/Auto Off Timer cannot be used at the same time.

*2 The weekly timer will not operate when any of the following conditions is in effect.

The timer feature is off; the system is in an malfunction state; a test run is in progress; the remote controller is undergoing self-check or remote controller check; the user is

in the process of setting a function; the user is in the process of setting the timer; the user is in the process of setting the current day of the week or time; the system is

under central control. (Specifically, the system will not carry out operations (unit on, unit off, or temperature setting) that are prohibited during these conditions.)

Operation No.

Day Setting

1. Be sure that you are at a standard control screen, and that the weekly timer indicator 1 is

shown in the display.

2. Press the Timer Menu button b, so that the "Set Up" appears on the screen (at 2). (Note

that each press of the button toggles the display between "Set Up" and "Monitor".)

3. Press the Timer ON/OFF (Set Day) button 9 to set the day. Each press advances the

display at 3 to the next setting, in the following sequence: "Sun Mon Tues Wed Thurs Fri

Sat"

"Sun"

...

"Fri"