Suzuki 990D0-03H06-ALU Instrucciones De Instalación

I N S T A L L A T I O N I N S T R U C T I O N S
Description : SIDE BOX COVER SET, ALUMINIUM OPTIC Part Number :
BURGMAN UH 125/200 K7-
Applications :
Contents
Ref. Description
Side box cover r, aluminium optic
①
Side box cover l ,aluminium optic
②
③ Installation instructions
①
Tools
Ref. Description
Required
(1) Neutral detergent
(2) Shop towel
Important ＷＡＲＮＩＮＧ / ＣＡＵＴＩＯＮ /
Please read this manual and follow its instructions carefully. To emphasize
special information, the symbol
and NOTE have special meanings. Pay special attention to the messages
highlighted by these signal words
Indicates potential hazard that could result in death or injury.
Indicates potential hazard that could result in vehicle damage.
NOTE:
Indicates special information to make maintenance easier or
instructions clearer.
1. Check that the kit includes all the parts listed in the first page.
Preparations
2. Check each part in the kit for scratches or any form of damage.
before
Installation 3. Park the motorcycle on a level ground.
4. Remove the ignition key from the switch and store it in a safe place.
5. If you feel difficult to install this product on your own after reading the
instructions, please consult with your nearest SUZUKI dealer.
990D0-03H06-ALU
10min.
Installation time :
QTY
② ③
Installation instructions
(1) (2)
ＮＯＴＥ
and words WARNING,CAUTION
▲ＷＡＲＮＩＮＧ
CAUTION
1/2
Installation
1
1
1
Side box Cover r ①
（１）
Set the Side box Cover r ① on the motorcycle
body to check correct positioning.
Install Side box cover l ② same procedure
Side box Cover r ①
Clean the attaching face on the motorcycle
（２）
body with the shop towel containing some
neutral detergent.
Thoroughly wipe off the detergent with wet
shop towel.
Dry the surface completely.
Shop Towel
（3） Peel off the entire release paper of the double-
sided adhesive tape on the back of the Side
box Cover r ①
Press-fit the Side box Cover r ① at the position
checked in (1) with soft shop towel.
Leave the attached cover as it is for 24 hours
after adhesion.
Install Side box cover l ② same procedure
2/2